TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 468 of 596

TM 9-2815-205-34

3-67. TURBOCHARGER REPAIR (ALL EXCEPT MODEL 5063-5299) (Cont)

(8)

(9)

(10)

(11)

(12)

(13)

(14)

(15)

CAUTION

Remove compressor wheel nut

from shaft with a double univer-

sal socket and tee handle to

prevent bending turbine wheel

shaft.

Place turbine wheel assembly (19) in

turbocharger holding fixture. Remove

self-locking nut (20) from shaft. Discard

self-locking nut.

Remove compressor wheel (21) from

turbine wheel assembly (19). For models

5063-5395, 5063-5398, and 5063-539F,

use press for removal.

CAUTION

Catch wheel shroud before it

falls from press. Wheel shroud

(22) will fall free when turbine

wheel assembly is removed.

Remove turbine wheel assembly (19) and

wheel shroud (22) from center housing (2).

On all except model 5063-5398 using

405681-1 turbocharger, remove retaining

ring (23) from turbine wheel assembly

(19). Discard retaining ring.

On models 5063-5392, 5063-5393, and

5063-539L, remove four screws (24)

fastening backplate (25) to center housing

(2).

On models 5063-5395, 5063-5398, and

5063-539F, bend down tabs of four lock

plates (26). Remove four screws (24) and

lock plates fastening backplate (25) to

center housing (2). Discard lock plates.

Tap backplate (25) lightly and remove from

center housing (2).

Remove seal ring (27) from groove in

center housing (2). Discard seal ring.

3-340

Change 1