TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 471 of 596

(3)

(4)

(5)

(6)

(7)

Inspect shaft for signs of scoring, scratches, or bearing seizure.

Check compressor wheel for signs of rubbing or blade damage. Check to see

galled .

Inspect seal parts for signs of rubbing or scoring

Inspect backplate for wear or damaged bore.

of running faces.

Inspect center housing for contact with rotating parts.

d. Assembly

(1)

(2)

(3)

(4)

(5)

(6)

(7)

Lubricate bearing (34) and bearing (38) with engine oil.

Install inner retaining ring (37), bearing washer

in compressor end of center housing (2).

TM 9-2815-205-34

wheel bore is not

(39), bearing (38), and outer retaining ring (37)

Install retaining ring (36), bearing washer (35), and bearing (34) in compressor end of center

housing (2).

On models 5063-5395, 5063-5398, and 5063-539F, install thrust washer (33) with hole and

cutout in thrust washer in alignment with pins (40). Install thrust washer with smooth side

against center housing (2).

On models 5063-5392, 5063-5393, and 5063-539L, insert thrust collar (32) into thrust washer

(29) and install thrust collar, thrust washer, and three socket head screws (28) in center housing

(2). Torque screws to 30-35 lb-in (3.4-3.9 N·m).

On models 5063-5395, 5063-5398, and 5063-539F, lubricate thrust collar (32) and thrust

washer (33) with engine oil. Install thrust collar snugly against thrust washer.

Install seal ring (27) in groove at compressor end of center housing (2).

Change 1

3-343