TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 478 of 596

TM 9-2815-205-34

3-60. GOVERNOR REPAIR (Cont)

(3) Governor housing assembly

(a)

(b)

(c)

(d)

(e)

(f)

(g)

3-350

Loosen nut (33) and remove

housing (36).

buffer screw (34) and spring (35) from side of governor

Remove retaining clip (37), two flat washers (38), and roller bearing (39) and control link

lever (40) assembly from grooved pin (41).

If two roller bearings (39) require replacement, support control link lever (40) assembly on a

sleeve (42) in press. Press two bearings out of lever assembly using bearing remover (43).

If necessary, press pin (48) from

differential lever (47).

Remove expansion plug (49) from bottom of governor housing (36). Discard expansion

plug.

Remove special screw (50) and flat washer (51) fastening governor bearing (52) in

governor housing (36).

Remove retaining clip (44) and flat

washer (45) from pin (46). Remove

differential lever (47) assembly.