TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 487 of 596

TM 9-2815-205-34

Section II. ENGINE PREPARATION

4-2. PREPARATION OF ENGINE FOR START-UP

This task covers: a. Installing Engine on Dynamometer

b. Priming Fuel System

c. Prelubrication of Oil Gallery (with Pressure Lubricator)

d. Prelubrication of Oil Gallery (without Pressure Lubricator)

e. Prelubrication of Turbocharger

f. Initial Start-up

INITIAL SETUP

MODELS

EXPENDABLE / DURABLE SUPPLIES

All

Oil, fuel (App C, Item 27)

Oil, engine (App C, Item 26)

TOOLS AND SPECIAL TOOLS

Tool kit, general mechanics (App B, Item 107)

When runnlng engine without air cleaners and turbocharger does not have

bulit-in inlet shield, install protective turbocharger air inlet shield prior to doing

maintenance. Contact with rotating blades will cause injury to personnel.

CAUTION

Run engine in clean area when air intake ducting is removed. Dirt, dust, and particles in

unfiltered air can enter engine and damage parts or cause mechanical failure.

a. Installing Engine on Dynamometer

(1)

(2)

(3)

(4)

(5)

(6)

Install engine on dynamometer.

Connect source of fuel supply and fuel return to engine. Fill fuel filters with clean grade DF2

fuel oil.

.. -

Connect same type of air cleaners used for engine when in vehicle.

NOT E

Locate air intake so that engine

inducts cool fresh air.

Connect engine cooling system to heat

exchanger or radiator similar to vehicle

type used to cool engine. Fill cooling

system with coolant (refer to applicable

vehicle lubrication order).

Provide an external source of 24 V dc

electrical power for starting engine.

Install oil pressure gage in oil gallery (1).

4-3

WARNING