TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 483 of 596

TM 9-2815-205-34

(m) Support governor housing (36) in press with upper end of shaft (54) against bed of press.

Align flat on shaft with flat in bore of shifter fork (57). Place sleeve over shaft and against

k

for . Press fork tight against shoulder on shaft.

(n) Place bearing (55), shield side toward the shifter fork (57), on lower end of shaft (54). With

upper end of shaft supported, press bearing against shoulder in bore of governor housing

(36) using sleeve against inner race of bearing.

(o) Lubricate bearing (52) and bearing (55) with engine oil.

(p) Support control link lever (40) on sleeve (42). Place roller bearing (39), numbered side up,

on lever and press flush using bearing installer (72). Invert lever and install second roller

bearing in same manner.

3-355