TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 481 of 596

TM 9-2815-205-34

(f)

(9)

(h)

(i)

(j)

(k)

Lubricate stop lever shaft (16) with engine oil and slide into cover (9) from bottom side.

Install special seal (18), shouldered washer (15), flat washer (14), and retainer ring (13) on

stop lever shaft (16).

Install flat washer (5) on throttle shaft

(4).

On model 5063-5398, install spacer

(3) on throttle shaft (4).

Install stop lever (12) on shaft (16).

Torque screw (11) to 84-106 lb-in

(10-12 N·m).

(a) Thread screw (27) into plunger

NOT E

Install original shims and spe-

cial washers if available. If

original shims and special

washers are not available,

install five shims and five

special washers.

Install remote control lever (2) on

shaft (4). Remote control lever must

contact flat washer (5) or spacer (3).

Torque screw (1) to 84-106 lb-in

(10-12 N·m).

(2) Governor spring pack

(25).

(b)

(c)

(d)

(e)

Install shims (30), special washers

(31), and spring (29) on plunger (25)

with thin special washers first.

Lubricate spring (29) and plunger (25)

with engine oil.

Place packing nut (28) over plunger (25) and thread nut (26) on screw (27) until

screw extends beyond nut.

Lubricate pin (32), spring seat (24), spring (23), and retainer (22) with engine oil

into end of plunger (25) as shown.

1/4 inch of

and install

3-353