TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 479 of 596

TM 9-2815-205-34

(h)

(i)

(j)

(k)

(I)

(m)

(n)

(o)

(p)

(q)

(r)

(s)

(t)

(u)

Place governor housing (36), top

down, on wooden blocks in press.

Using a short 3/8 inch-diameter rod

(53), press operating shaft (54) free of

bearing (55).

Insert 9/16 inch open end wrench (56)

between shifter fork (57) and governor

housing (36), Using a 3/8 inch-

diameter rod (53), press operating

shaft (54) out of shifter fork.

Remove operating shaft (54), bearing

(52), operating shaft lever assembly

(58), and shifter fork (57) from

governor housing (36).

Press operating shaft (54) from

operating shaft lever assembly (58)

and bearing (52).

If necessary, press pin (46) from

operating shaft lever (59).

On models 5063-5299 and

5063-5398, remove nut (60) and

screw (61) from operating shaft lever

(59).

On models 5063-5395, 5063-5392,

5063-5393, 5063-539F, and

5063-539L, remove bolt (62), special

nut (63), and nut (64) from operating

shaft lever (59).

Press ball bearing (55) from governor

housing (36).

If necessary, remove plug (65) from

side of governor housing (36). Discard

plug.

If necessary, remove two pins (66)

from top of governor housing (36).

If necessary, remove two adapters

(67) from sides of governor housing

(36).

If necessary, remove two pins (68)

from front and pin (69) from rear of

governor housing (36).

If necessary, remove two drive screws

(70) and plate (71) from side of

governor housing (36).

If necessary, remove pin (41) from

inside governor housing (36).

Change 1

3-351