TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 495 of 596

(4)

(5)

(6)

(7)

TM9-2815-205-34

NOT E

Proper timing adjustment of fuel injector is achieved when rotating the injector timing

gage wipes a drop of clean lubrication oil on injector follower to a thin even film behind

flat

of

gage.

-

Turn push rod (4) to adjust injector follower 3) height until flat of timing gage

over top of injector follower and wipes the oil clean.

Hold injector push rod (4) and tighten push rod locknut (5). Lightly tap rocker

wrench to release friction.

NOT E

Mark each rocker arm with a crayon or marker after adjustment.

(9) just passes

arm (12) with

Check injector timing again. If adjustment is required repeat steps (2) thru (5).

Time remaining five fuel injectors as outlined in steps (1) thru (6).

c. Governor Gap Adjustment

NOT E

Before proceeding with gover-

nor adjustments, disconnect

linkage from stop lever (1) and

speed control lever (2).

(1) On all except model 5063-5299, loosen

. .

two nuts (13) on throttle delay U-bolt (14)

on right injector control tube (15). Injector

control tube must move freely in U-bolt.

•

•

Avoid contact with hot mani-

foids, pulleys, and other

moving parts to avoid per-

sonal injury.

Wear proper ear protection

when running engine. Noise

volume of engine can cause

hearing loss or injury.

4-11

WARNING