TM-9-2815-205-34
ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
AUGUST 1992
TM-9-2815-205-34 - Page 497 of 596
TM 9-2815-205-34
NOT E
On models 5063-5395 and 5063-539F, install fuel line clip on top of governor cover.
Replace governor cover gasket only if damaged during removal.
(7)
(8)
(9)
(10)
(11)
(12)
(13)
(14)
Remove seven screw assemblies (24),
governor cover assembly (25), and gasket
(26) from top of governor.
On models 5063-5392, 5063-5393,
5063-5395, 5063-539F and 5063-539L
loosen locknut (27) and screw starting aid
screw (28) into gap adjusting screw (29).
CAUTION
When manual overriding gover-
nor, watch engine controls
closely and do not allow engine
to overspeed. Extended engine
operation above speed limits
can damage engine.
Start and run engine between 1100-1300
RPM by manual operation of differential
lever (30).
Check gap between low-speed spring cap
(31) and high-speed spring plunger (32)
with a thickness gage. Gap should be
0.002-0.004 inch. If necessary, set gap
again with adjusting screw (29).
On models 5063-5299 and 5063-5398,
hold gap adjusting screw (29) and tighten
locknut (27).
Check gap with engine running between
1100-1300 RPM, adjust gap if necessary.
Stop engine by moving differential lever
(30) to NO FUEL position.
CAUTION
Ensure governor stop lever moves injector racks freely to NO FUEL position before
installing governor cover. Any binding of stop lever and injector racks could result in
failure to stop a run-away engine. Extended engine operation above speed limits can
damage engine.
NOT E
On models 5063-5392, 5063-5393, 5063-5395, 5063-539F and 5063-539L, install
governor cover after starting aid screw adjustment.
On models 5063-5299 and 5063-5398, install governor cover (25), gasket (26), and seven
screw assemblies (24) to governor. Tighten screws securely.
Change 1
4-13
Back to Top
