TM-9-2815-210-34-2-2
ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER
TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2
APRIL 1981
TM-9-2815-210-34-2-2 - Page 79 of 968
TM 9-2815-210-34-2-2
FRAME 39
NOTE
Main thrust bearing halves (1) are different from other
main bearing halves (2).
Main thrust bearing halves
have a flange (3) on each side. Wear limits are same for
both kinds of main bearing half.
Readings must be within limits given in table 4-14. If
readings are not within given limits, throw away all 14
main bearing halves (1 and 2) and get a new standard
size main bearing kit.
1.
Measure thickness of all 14 main bearing halves (1 and 2).
2.
If main bearing halves (1 and 2) were changed, do step 1 again for new main
bearing halves.
GO TO FRAME 42
4-60
Back to Top
