TM-9-2815-210-34-2-2
ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER
TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2
APRIL 1981
TM-9-2815-210-34-2-2 - Page 85 of 968
TM 9-2815-210-34-2-2
FRAME 42
1.
2.
3.
4.
GO
NOTE
Main bearing caps (1) and bearing saddles (2) are called
by numbers one to seven counting from front to rear of
crankcase (3).
The number one main bearing cap (1) has oil pump idler
gear shaft (4).
Put number one main bearing cap (1) on number one bearing saddle (2) with
oil pump idler gear shaft (4) facing out as shown.
Coat two bolts (5) and washers (6) lightly with engine lubricating oil. Put
in and hand tighten two bolts and washers.
Using torque wrench, tighten two bolts (5) to 80 to 90 pound-feet.
Using torque wrench, tighten two bolts (5) to 115 to 120 pound-feet.
TO FRAME 43
4-66
Back to Top
