TM-9-2815-210-34-2-2
ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER
TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2
APRIL 1981
TM-9-2815-210-34-2-2 - Page 94 of 968
TM 9-2815-210-34-2-2
FRAME 51
1.
2.
3.
NOTE
Seven main bearing caps (1) are line bored with
crankcase (2).
If any main bearing cap is damaged,
crankcase and all main bearing caps must be thrown
away.
Main bearing bores are called by numbers one to seven
counting from front to rear of crankcase (2).
Using dial indicator, measure inside diameter of number five bearing bore (3).
Inside diameter must be 3.9370 to 3.9380 inches.
If inside diameter of number five bearing bore (3) is not 3.9370 to 3.9380
inches, throw away crankcase (2) and get a new one.
NOTE
New crankcase (2) will come with new main bearing caps
(1).
If diameter of number five main bearing bore (3) is 3.9370 to 3.9380 inches,
-.
take out two bolts and washers (4) and take off number five main bearing
cap (1).
GO TO FRAME 52
4-75
Back to Top
