TM-9-2815-210-34-2-2
ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER
TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2
APRIL 1981
TM-9-2815-210-34-2-2 - Page 95 of 968
TM 9-2815-210-34-2-2
FRAME 52
1.
2.
3.
4.
NOTE
Main bearing caps (1) and bearing saddles (2) are called
by numbers one to seven counting from front to rear of
crankcase (3).
Put number six main bearing cap (1) on number six bearing saddle (2).
Mounting holes in number six main bearing cap must line up with screw holes
in number six bearing saddle.
Coat two bolts (4) and washers (5) lightly with engine lubricating oil. Put in
and hand tighten two bolts and washers.
Using torque wrench, tighten two bolts (4) to 80 to 90 pound-feet.
Using torque wrench, tighten two bolts (4) to 115 to 120 pound-feet.
GO TO FRAME 53
4-76
Back to Top
