TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 104 of 968

TM 9-2815-210-34-2-2

FRAME 61

NOTE

Main bearing caps (1) with bearing halves (2) and main

bearing saddles (3) are called by numbers one to seven

counting from front to rear of crankcase (4).

Number two main bearing cap (1) has a flat mounting

surface (5) for mounting the oil pump.

1.

Put number two main bearing cap (1) with bearing half (2) on number two

main bearing saddle (3). Mounting holes in number two main bearing cap

must line up with screw holes in number two bearing saddle.

2.

Coat two bolts (6) and washers (7) lightly with engine lubricating oil. Put

in and hand tighten two bolts and washers.

3.

Using torque wrench, tighten two bolts (6) to 80 to 90 pound-feet.

4.

Using torque wrench, tighten two bolts (6) to 115 to 120 pound-feet.

GO TO FRAME 62

4-85