TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

  TM-9-2815-210-34-2-2 - Page 106 of 968

TM 9-2815-210-34-2-2
FRAME 63
1.
2.
3.
4.
5.
NOTE
Main bearing caps (1) with bearing halves (2) and main
bearing saddles (3) are called by numbers one to seven
counting from front to rear of crankcase (4).
Number three, number five, and number six main bearing
caps (1) look the same. They are marked with their
number.
Put number three main bearing cap (1) with bearing half (2) on number three
main bearing saddle (3). Mounting holes in number three main bearing cap
must line up with screw holes in number three main bearing saddle.
Coat two bolts (5) and washers (6) lightly with engine lubricating oil. Put in
and hand tighten two bolts and washers.
Using torque wrench, tighten two bolts (5) to 80 to 90 pound-feet.
Using torque wrench, tighten two bolts (5) to 115 to 120 pound-feet.
Do this frame again for number five main bearing cap with bearing half
and number six main bearing cap with bearing half.
GO TO FRAME 64
4-87


Back to Top