TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 109 of 968

TM 9-2815-210-34-2-2

FRAME 66

1.

2.

3.

NOTE

All seven lower main bearing halves (1) have an aline-

ment tab (2) at center as shown.

Main bearing halves (1) and main bearing caps (3) are

called by numbers one to seven counting from front to

rear of crankcase (4). Used main bearing halves are

marked with a number in alinement tab (2).

The number seven main bearing cap (3) has a slot (5) on

each side for rubber oil seals.

Spread a thin coat of Prussian blue on surface of number seven lower q ain

bearing half (1) which rests against number seven main bearing cap (3).

Hold number seven lower main bearing half (1) on number seven main bearing

cap (3). Aline tab (2) must fit in notch (6) in number seven main

bearing cap.

Put a light coat of engine lubricating oil

on

edges (7) of number seven main

bearing cap (3).

GO TO FRAME 67

4-90