TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

  TM-9-2815-210-34-2-2 - Page 110 of 968

TM 9-2815-210-34-2-2
FRAME 67
NOTE
Main bearing caps (1) with bearing halves (2) and main
bearing saddles (3) are called by numbers one to seven
counting from front to rear of crankcase (4).
Number seven main bearing cap has a slot (5) on each
side for rubber oil seal.
1.
Put number seven main bearing cap (1) with bearing half (2) on number
seven main bearing saddle (3).
Mounting holes in number seven main bearing
cap must line up with screw holes in number seven bearing saddle.
2.
Coat two bolts (6) and washers (7) lightly with engine lubricating oil. Put
in and hand tighten two bolts and washers.
3.
Using torque wrench, tighten two bolts (6) to 80 to 90 pound-feet.
4.
Using torque wrench, tighten two bolts (6) to 115 to 120 pound-feet.
GO TO FRAME 68
4-91


Back to Top