TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 103 of 968

TM 9-2815-210-34-2-2

FRAME 60

1.

2.

3.

GO

NOTE

All seven lower main bearing halves (1) have an aline-

ment tab (2) at center as shown.

Main bearing halves (1) and main bearing caps (3) are

called by numbers one to seven counting from front to

rear of crankcase (4).

Used main bearing halves are

marked with a number in alinement tab (2).

Number two main bearing cap (3) has a flat mounting

surface (5) for mounting oil pump.

Spread a thin coat of Prussian blue on surface of number two lower main

bearing half (1) which rests against number two bearing cap (3).

Hold number two lower main bearing half (1) on number two main bearing

cap (3).

Alinement tab (2) must fit in notch (6) in number two main bearing

cap.

Put a light coat of engine lubricating oil on edges (7) of number two main

bearing cap (3).

TO FRAME 61

4-84