TM-9-2815-210-34-2-2
ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER
TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2
APRIL 1981
TM-9-2815-210-34-2-2 - Page 93 of 968
TM 9-2815-210-34-2-2
FRAME
50
1.
2.
3.
4.
NOTE
Main bearing caps (1) and bearing saddles (2) are called
by numbers one to seven counting from front to rear of
crankcase (3).
Number five main bearing cap (1) is marked with the num-
ber 5.
Put number five main bearing cap (1) on number five bearing saddle (2).
Mounting holes in number five main bearing cap must line up with screw
holes in number five bearing saddle.
Coat two bolts (4) and washers (5) lightly with engine lubricating oil. Put
in and hand tighten two bolts and washers.
Using torque wrench, tighten two bolts (4) to 80 to 90 pound-feet.
Using torque wrench, tighten two bolts (4) to 115 to 120 pound-feet.
GO TO FRAME 51
4-74
Back to Top
