TM-9-2815-210-34-2-2
ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER
TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2
APRIL 1981
TM-9-2815-210-34-2-2 - Page 89 of 968
TM 9-2815-210-34-2-2
FRAME 46
NOTE
Seven main bearing caps (1) and seven
(2) are called by numbers one to seven
front to rear of crankcase (3).
The number three main bearing cap (1)
the number 3.
bearing saddles
counting from
is marked with
1.
2.
3.
4.
GO
Put number three main bearing cap (1) on number three bearing saddle (2).
Mounting holes in number three main bearing cap must line up with screw
holes in number three bearing saddle.
Coat two bolts (4) and washers (5) lightly with engine lubricating oil. Put
in and hand tighten two bolts and washers.
Using torque wrench, tighten two bolts (4) to 80 to 90 pound-feet.
Using torque wrench, tighten two bolts (4) to 115 to 120 pound-feet.
TO FRAME 47
4-70
Back to Top
