TM-9-2815-210-34-2-2
ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER
TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2
APRIL 1981
TM-9-2815-210-34-2-2 - Page 81 of 968
TM 9-2815-210-34-2-2
FRAME 40
1.
2.
NOTE
Main thrust bearing halves (1) are different from other
main bearing halves (2). Main thrust bearing halves
have a flange (3) on each side. Wear limits are same for
both kinds of main bearing halves.
Readings must be within limits given in table 4-15. If
readings are not within given limits, throw away all 14
main bearing halves (1 and 2) and get a new 0.0100-
undersize main bearing kit.
Measure thickness of all 14 main bearing halves (1 and 2).
If main bearing halves (1 and 2) were changed, do step 1 again for new
main bearing halves.
GO TO FRAME 42
4-62
Back to Top
