TM-9-2815-210-34-2-2
ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER
TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2
APRIL 1981
TM-9-2815-210-34-2-2 - Page 87 of 968
TM 9-2815-210-34-2-2
FRAME 44
1.
2.
3.
4.
NOTE
Main bearing caps (1) and bearing saddles (2) are called
by numbers one to seven counting from front to rear of
crankcase (3).
Number two main bearing cap (1) has a flat mounting sur-
face (4) for mounting oil pump.
Put number two main bearing cap (1) on number two bearing saddle (2).
Mounting holes in number two main bearing cap must line up with screw
holes in number two bearing saddle.
Coat two bolts (5) and washers (6) lightly with engine lubricating oil, Put
in and hand tighten two bolts and washers.
Using torque wrench, tighten two bolts (5) to 80 to 90 pound-feet.
Using torque wrench, tighten two bolts (5) to 115 to 120 pound-feet.
GO TO FRAME 45
4-68
Back to Top
