TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

  TM-9-2815-210-34-2-2 - Page 88 of 968

TM 9-2815-210-34-2-2
FRAME 45
1.
2.
3.
NOTE
Seven main bearing caps (1) are line bored with crank-
case (2).
If any main bearing cap is damaged, the crank-
case and all main bearing caps must be thrown away.
Bearing bores (3) are called by numbers one to seven
counting from front to rear of crankcase (2).
Using dial indicator, measure inside diameter of number two bearing bore (3).
Inside diameter must be 3.9370 to 3.9380 inches.
If inside diameter of number two main bearing bore (3) is not 3.9370 to
3.9380 inches, throw away crankcase (2) and get a new one.
NOTE
New crankcase (2) will come with new bearing caps (1).
If diameter of number
two
main bearing bore (3) is 3.9370 to 3.9380 inches
take out two bolts and washers (4), and take off number two main bearing
cap (1).
GO TO FRAME 46
4-69


Back to Top