TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 891 of 968

TM 9-2815-210-34-2-2

FRAME 2

1.

2.

3.

4.

5.

6.

7.

NOTE

Fill in standard engine test report form used by the

installation where this test is being done.

Open load control valve (1) until POWER gage (2) reads 15 HP. Close load

control valve.

Set throttle (3) to 1800 RPM on SPEED gage (4).

If POWER gage (2) is above 15 HP, open unload valve (5) to bring it down to

15 HP. Close unload valve.

Reset throttle (3), if needed, to keep 1800 rpm.

Run engine at 1800 rpm at 15 HP for 10 minutes, then write down lubricating

oil pressure and water temperature.

Open unload valve (5) until POWER gage (2) reads 1 to 5 HP.

Stop engine.

GO TO FRAME 3

6-36