TM-9-2815-225-34-P
ENGINE, DIESEL: 6 CYLINDER IN-LINE TURBOCHARGED, CUMMINS MODEL NTC-400
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST
JULY 2005
TM-9-2815-225-34-P - Page 460 of 736
TM 9-2815-225-34&P
0048 00
0048 00-26
BIG CAM III ENGINE INSTALLATION (Contd)
NOTE
Use three assistants or lifting strap and lifting device to install
hood to vehicle.
91.
Install hood (3) on hood hinges (4) with two hood hinge bolts (2) and new locknuts (1).
WARNING
When installing hood tilt assist cables, hood must be supported.
Failure to do so may result in damage to equipment or injury to
personnel.
92.
Support hood (3) and install two tilt assist cables (5) connected to chain links (6) on chain links
nuts (7).
93.
Install lighting harness (13) on hood (3) with four lighting harness clamps (8), washers (9),
screws (10), and new plastic tie (12).
94.
Connect four electrical connectors (11) to lighting harness (13).
Figure 44. Hood Hinge Installation.
2
1
2
3
1
4
4
Back to Top
