TM-9-2815-225-34-P
ENGINE, DIESEL: 6 CYLINDER IN-LINE TURBOCHARGED, CUMMINS MODEL NTC-400
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST
JULY 2005
TM-9-2815-225-34-P - Page 466 of 736
TM 9-2815-225-34&P
0049 00
0049 00-4
BIG CAM I ENGINE INSTALLATION (Contd)
Figure 3. Transmission Shift Control Cable Installation.
8
9
10
12
11
7
14
5
6
4
3
2
1
13
16.
Install transmission floor shifter assembly (2) and floor pan access cover (1) to cab floor with ten
floor pan access cover screws (4). Tighten screws (4) 15–20 lb-ft (20–27 N
•
m).
17.
Position floor mat (3) around transmission floor shifter assembly (2) and floor pan access cover (1).
18.
Install trunion (10) in transmission shift lever (8) with new trunion retaining pin (9).
NOTE
Refer to TM 2320-283-20-2 for shift control cale adjustment
procedures.
19.
Install transmission shift control cable assembly (14) to transmission shift control cable mounting
bracket (13) with spacer plate (7), U-bolt (6), two new lockwashers (11), and new locknuts (12).
Ensure grommet (5) is correctly positioned in U-bolt (6).
20.
Install rear cooler hose bracket (17) to transmission (16) with rear cooler hose bracket washer (18)
and screw (19).
21.
Install middle cooler hose bracket (20) to oil pan (21) with middle cooler hose bracket screw (22).
22.
Install front hose clamp (33) on cooler hose bracket (34) with front hose clamp screw (32) and nut (35).
23.
Install positive battery cable (23), starter motor ground strap (28), and negative battery cable (25)
on starter motor (24) with new starter motor terminal lockwasher (26) and nut (27).
24.
Install ground strap (31) and starter motor ground strap (28) on engine (15) with new ground strap
starwasher (29) and bolt (30).
25.
Install transmission modulator control bracket (40) on engine (15) with two new transmission
modulator control bracket lockwashers (41) and bolts (42).
26.
Install transmission modulator control link (50) on transmission modulator control bracket (40)
with U-bolt (43), spacer plate (44), two washers (45), and nuts (46).
27.
Install transmission modulator control link (50) and washer (48) on fuel control lever (51) with new
retaining pin (47).
28.
Install accelerator link (49) on fuel control lever (51) accelerator link washer (37), return spring
clip (38), and nut (36).
29.
Install return spring (39) on transmission modulator control bracket (40) and spring clip (38).
Back to Top
