MWO-5-2350-262-35-4
ARMORED COMBAT EARTHMOVER (ACE), M9
MODIFICATION WORK ORDER
MWO-5-2350-262-35-4 - Page 36 of 207
MWO 5--2350--262--35--4
3--7
SECTION II INSTALLATION OF HDC PRIMARY MANIFOLD ASSEMBLY,
MANUAL SHUT–OFF VALVE V23, AND LEFT MAIN MANIFOLD PRESSURE
TRANSDUCER T7 -- CONTINUED
3--1
REMOVAL/DISASSEMBLY OF DCV BANK, SUSPENSION VALVE AND OTHER
ITEMS TO ACCOMMODATE INSTALLATION -- CONTINUED
NOTE
Step p below applies to Figure 3--3.
NOTE
Clamp assembly is shown disassembled in Figure 3--3 with only the lower portion of the
clamp assembly attached to the bracket. Figure 3--3 shows the lower portion of the
clamp assembly attached to the new inboard angle bracket that will be installed, and not
the existing inboard mounting bracket that is removed and discarded in step q.
p.
Remove clamp assembly (1) from inboard valve bracket (2). Retain two bolts (4) and two flat washers
(3). It is recommended that clamp assembly not be disassembled but remain intact with three hoses
clamped in place. It is not necessary to disassemble clamp assembly to perform this modification.
Figure 3--3. Components to be Replaced -- Clamp Assembly
Back to Top
