MWO-5-2350-262-35-4
ARMORED COMBAT EARTHMOVER (ACE), M9
MODIFICATION WORK ORDER
MWO-5-2350-262-35-4 - Page 27 of 207
MWO 5--2350--262--35--4
2--8
SECTION IV INSTALLATION OF UMBILICAL CABLE DISCONNECT
BRACKET
WARNING
Ensure that vehicle power is off and battery disconnected. Failure to comply could result
in severe injury or death.
a.
Ensure that vehicle battery power is disconnected, per TM 5--2350--262--20--1, Battery Cable
Replacement, Negative Cables Disconnect.
NOTE
Steps b and c apply to Figure 2--5.
b.
Locate suspension control levers in driver’s compartment. Refer to Figure 2--5 and TM 5--2350--262--10.
Figure 2--5 shows the mounting hole already drilled in the forward left bulkhead with inserts,
MS51831--102, (1) installed.
c.
Remove three mounting bolts and three washers from switch panel and move switch panel slightly left,
away from front of driver’s compartment. Refer to TM 5--2350--262--20--1.
Figure 2--5. Driver’s Compartment Area for Installation of Umbilical Cable Disconnect Bracket
Back to Top
