MWO-5-2350-262-35-4
ARMORED COMBAT EARTHMOVER (ACE), M9
MODIFICATION WORK ORDER
MWO-5-2350-262-35-4 - Page 32 of 207
MWO 5--2350--262--35--4
3--3
SECTION II INSTALLATION OF HDC PRIMARY MANIFOLD ASSEMBLY,
MANUAL SHUT–OFF VALVE V23, AND LEFT MAIN MANIFOLD PRESSURE
TRANSDUCER T7
3--1
REMOVAL/DISASSEMBLY OF DCV BANK, SUSPENSION VALVE AND OTHER
ITEMS TO ACCOMMODATE INSTALLATION.
WARNING
Ensure hydraulic components are cool before performing maintenance. Failure to comply
could result in personal injury or burns.
a.
Identify and tag all hydraulic hoses and tubes attached to the DCV bank control valves and the
suspension (sprung/unsprung) valve. Refer to TM 5--2350--262--20--1, to identify specific DCV bank
valves and hydraulic ports.
WARNING
The DCV bank weighs approximately 60 pounds. DCV bank must be fully supported
when being removed from or installing on mounting brackets. Use proper lifting
techniques when removing or installing DCV bank from vehicle. Failure to do so could
result in serious personal injury.
WARNING
The primary manifold assembly weights approximately 40 pounds. The assembly must
be fully supported when installing. Failure to do so could result in serious personal injury.
b.
Disconnect hose from ejector cylinder and remove other end from DCV bank.
c.
Remove suspension (sprung/unsprung) valve from mounting brackets (as described in step o.) before
removing the DCV bank, to facilitate removal of the DCV bank.
Back to Top
