MWO-5-2350-262-35-4
ARMORED COMBAT EARTHMOVER (ACE), M9
MODIFICATION WORK ORDER
MWO-5-2350-262-35-4 - Page 56 of 207
MWO 5--2350--262--35--4
3--27
SECTION II INSTALLATION OF HDC PRIMARY MANIFOLD ASSEMBLY,
MANUAL SHUT–OFF VALVE V23, AND LEFT MAIN MANIFOLD PRESSURE
TRANSDUCER T7 -- CONTINUED
3--4 MOUNTING AND INSTALLATION OF HDC PRIMARY MANIFOLD ASSEMBLY --
CONTINUED
NOTE
Step c below applies to Figure 3--13.
c.
Reattach clamp assembly (6) to new inboard angle bracket,12496952, (7) with two previously removed
bolts and two flat washers (hidden from view). Items 3, 4, and 5 identify the three hoses clamped in
place. Items 1 and 2 are mounting hardware that attach the inboard angle bracket to vehicle hull as
described below in step d.
Figure 3--13. Installation of Clamp Assembly on Inbound Angle Bracket
NOTE
Steps d through f below apply to Figure 3--14 (also reference to Figure 3--13).
d.
Mount inboard angle bracket, 12496952, (1) and attached clamp assembly to existing holes in inboard
portion of vehicle hull with two new locking screws, B1821BH050C113L, (3) and two flat washers,
MS27183--18, (2) retained from removal of DCV bank inboard mounting bracket (Figure 3--13 shows the
inboard angle bracket mounted to hull with clamp assembly attached).
Back to Top
