MWO-5-2350-262-35-4
ARMORED COMBAT EARTHMOVER (ACE), M9
MODIFICATION WORK ORDER
MWO-5-2350-262-35-4 - Page 58 of 207
MWO 5--2350--262--35--4
3--29
SECTION II INSTALLATION OF HDC PRIMARY MANIFOLD ASSEMBLY,
MANUAL SHUT–OFF VALVE V23, AND LEFT MAIN MANIFOLD PRESSURE
TRANSDUCER T7 -- CONTINUED
3--4 MOUNTING AND INSTALLATION OF HDC PRIMARY MANIFOLD ASSEMBLY --
CONTINUED
WARNING
It is necessary to fully support weight of primary manifold assembly (approximately 40
pounds) when securing manifold assembly to weldment bracket. Failure to do so could
result in serious personal injury.
NOTE
Step g below applies to Figure 3--15.
NOTE
When installing primary manifold assembly, the top of the manifold assembly mounting
plate should be lowered and placed behind weldment bracket and eased upward into
proper installation position.
g.
Fully supporting weight of primary manifold assembly, 19496943, (4), install mounting plate, 12496959,
(1) (and attached primary manifold assembly (4)) to weldment bracket, 12496944, with five locking
screws, B1821BH038C100L, (2) and five flat washers, 10910174--3, (3). Do not completely tighten
screws at this time.
Figure 3--15. Mounting and Installation of HDC Primary Manifold Assembly
Back to Top
