MWO-5-2350-262-35-4
ARMORED COMBAT EARTHMOVER (ACE), M9
MODIFICATION WORK ORDER
MWO-5-2350-262-35-4 - Page 65 of 207
MWO 5--2350--262--35--4
3--36
SECTION II INSTALLATION OF HDC PRIMARY MANIFOLD ASSEMBLY,
MANUAL SHUT–OFF VALVE V23, AND LEFT MAIN MANIFOLD PRESSURE
TRANSDUCER T7 -- CONTINUED
3--6 MOUNTING OF DIRECTIONAL CONTROL VALVE (DCV) BANK AND SUSPENSION
VALVE -- CONTINUED
NOTE
Steps d and e below apply to Figure 3--22 (Upper).
d.
Fully supporting the entire weight of DCV bank, install DCV bank (1) on weldment bracket with four saved
hex cap screws, B1821BH038C150N, (2), four saved flat washers, MS27183--14, (4), and four new
self--locking nuts, MS17829--6C, (3). Callout (6) shows location of another set of DCV bank mounting
hardware on upper portion of weldment bracket. Do not completely tighten hex cap screws at this time.
Refer to TM 5--2350--262--20--2, Directional Control Valve Replacement.
e.
Attach mechanical control linkages to DCV bank valves with six cotter pins, MS24665--132, (5), and
adjust linkages as necessary. Refer to TM 5--2350--262--20--2, Hydraulic Control Levers and Linkage
Adjustment, if necessary to adjust linkages.
Figure 3--22. Mounting of DCV Bank and Suspension (Sprung/Unsprung) Valve/Upper View)
Back to Top
