MWO-5-2350-262-35-4
ARMORED COMBAT EARTHMOVER (ACE), M9
MODIFICATION WORK ORDER
MWO-5-2350-262-35-4 - Page 66 of 207
MWO 5--2350--262--35--4
3--37
SECTION II INSTALLATION OF HDC PRIMARY MANIFOLD ASSEMBLY,
MANUAL SHUT–OFF VALVE V23, AND LEFT MAIN MANIFOLD PRESSURE
TRANSDUCER T7 -- CONTINUED
3--6 MOUNTING OF DIRECTIONAL CONTROL VALVE (DCV) BANK AND SUSPENSION
VALVE -- CONTINUED
NOTE
Steps f and g below apply to Figure 3--23 (Lower).
f.
Install suspension (sprung/unsprung) valve (5) on weldment bracket with four saved hex cap screws,
B1821BH038C150N, (4), four saved flat washers, MS27183--14, (1), and four new self--locking nuts,
MS17829--6C, (3). Do not completely tighten hex cap screws at this time. Refer to TM
5--2350--262--20--2, Sprung/Unsprung Valve Replacement.
g.
Install previously removed hydraulic hoses on suspension (sprung/unsprung) valve and attach
mechanical control linkage to valve with cotter pin, MS24665--132, (2). Adjust linkage as necessary.
Refer to TM 5--2350--262--20--2, Hydraulic Control Levers and Linkage Adjustment, if necessary to adjust
linkage.
Figure 3--23. Mounting of DCV Bank and Suspension (Sprung/Unsprung) Valve/Lower View)
Back to Top
