MWO-5-2350-262-35-4
ARMORED COMBAT EARTHMOVER (ACE), M9
MODIFICATION WORK ORDER
MWO-5-2350-262-35-4 - Page 57 of 207
MWO 5--2350--262--35--4
3--28
SECTION II INSTALLATION OF HDC PRIMARY MANIFOLD ASSEMBLY,
MANUAL SHUT–OFF VALVE V23, AND LEFT MAIN MANIFOLD PRESSURE
TRANSDUCER T7 -- CONTINUED
3--4 MOUNTING AND INSTALLATION OF HDC PRIMARY MANIFOLD ASSEMBLY --
CONTINUED
WARNING
Weldment bracket must be installed before attempting to install HDC primary manifold
assembly to provide necessary support during installation of manifold assembly. Failure
to do so could result in serious personnel injury.
e.
Attach outboard weldment bracket, 12496944, (4) to existing holes in left side (driver’s left) of vehicle hull
with three new locking screws, B1821BH050C113L, (5) and three flat washers, MS27183--18, (6)
retained from removal of DCV bank old outboard mounting bracket.
f.
Secure outboard weldment bracket (4) to inboard angle bracket (1) with two screws,
B1821BH038C125N, (7), four flat washers, 10910174--3, (8), and two self--locking nuts, MS17829--6C,
(9) as shown.
Figure 3--14. Installation of Mounting Brackets
Back to Top
