MWO-5-2350-262-35-4
ARMORED COMBAT EARTHMOVER (ACE), M9
MODIFICATION WORK ORDER
MWO-5-2350-262-35-4 - Page 83 of 207
MWO 5--2350--262--35--4
3--54
SECTION III MODIFICATION OF MAIN HYDRAULIC FILTER AREA
-- CONTINUED
3--10 MODIFICATIONS TO MAIN PUMP RIGHT HYDRAULIC FILTER AREA – INCLUDING
ADDITION OF BALL VALVE V21 AND PRESSURE TRANSDUCER T3
NOTE
Steps a through g below apply to Figure 3--35.
NOTE
Ball valve V21 requires a configuration change from right--hand operation to left--hand
operation prior to installing valve to provide necessary space in filter area for proper
operation.
NOTE
Do not adjust tension screw on bottom of handle, at any time.
a.
Steps d and e change manual ball valve, BVHP--O8--SSS--1NG, configuration from right hand operation
to left hand operation by rotating cam plate 90
_
counterclockwise (CCW). This manual ball valve is
functionally designated as V21.
b.
Visually inspect position of ball valve by looking through valve body (5) to ensure that the valve is open.
Ensure valve is open with valve handle (1) in the open position as shown in the top portion of
Figure 3--35.
c.
Remove hex head allen screw (2) attaching handle (1) to ball valve, BVHP--O8--SSS--1NG, body (5). Do
not adjust or remove tension screw (4) when removing handle (1) from valve body (5).
d.
Remove handle (1) and spacer (3) from ball valve body (5) to expose cam plate (6) and stop pin (7). As
supplied, and with handle removed, cam plate (6) is configured as shown in middle portion of
Figure 3--35 (right hand operation configuration).
e.
Lift cam plate (6) from ball valve body (5) and rotate cam plate (6) 90
_
CCW so pin (7) on ball valve body
(5), with respect to cam plate, is positioned as shown on lower portion of Figure 3--35 for left hand
operation.
f.
Install spacer (3) and handle (1) on ball valve (now configured for left--hand operation).
g.
Install hex head allen screw (2) and tighten to secure handle (1) on valve body (5).
Back to Top
