SMI-9-2320-387-14P-1
TRUCK, UTILITY: EXPANDED CAPACITY
SUPPLEMENTAL OPERATION, MAINTENANCE, AND REPAIR PARTS INSTRUCTIONS
JULY 2004
SMI-9-2320-387-14P-1 - Page 191 of 671
11-59.3. TURRET LOCK REPLACEMENT
This task covers:
a. Removal
b. Installation
a. Removal
Remove two locknuts (6), washers (1), capscrews (2), washers (1), turret lock (5), and spacer(s) (4) from
weapon station (3). Discard locknuts (6).
INITIAL SETUP:
Applicable Models
M1151
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Two locknuts (Appendix G, Item 106)
Manual References
TM 9-2320-387-24P
b. Installation
Install spacer(s) (4) and turret lock (5) on weapon station (3) with two washers (1), capscrews (2),
washers (1), and locknuts (6). Tighten locknuts (6) to 37 lb-ft (50 N
•
m).
NOTE
Install same amount of spacers that were removed between
bottom of weapon station and turret lock. Amount of spacers
may be adjusted to correct lock handle binding. Refer to
TM 9-2320-387-24P if more spacers are needed.
SMI 9-2320-387-14&P-1
Change 4
11-112.5
Back to Top
