TB-9-2320-279-13-P-2
TECHNICAL BULLETIN; CREW PROTECTION KIT
OPERATOR’S, UNIT AND DIRECT SUPPORT MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LISTS (RPSTL)
SEPTEMBER 2005
TB-9-2320-279-13-P-2 - Page 98 of 460
TB 9-2320-279-13&P-2
DOOR LATCH ADJUSTMENT - CONTINUED
0016 00
0016 00-2
ADJUSTMENT
NOTE
When horizontal and vertical adjustments are correct, the upper lever (1) and lower lever (4) will contact the
striker at the same time.
1.
From inside cab, slowly close door and observe latch (2) and striker contact points.
2.
If vertical adjustment is necessary, loosen three vertical adjustment bolts (3) and correctly position latch (2).
3.
If loosened, tighten three bolts (3).
4.
If horizontal adjustment is necessary, remove three locknuts, (9), washers (8), bolts (6) and washers (7) from latch
bracket (5). Discard locknuts.
5.
Add washers between latch bracket (5) and door to correctly position latch (2).
6.
If removed, install three washers (7), bolts (6), washers (8), and new locknuts (9) on latch bracket (5).
417-031
1
2
3
4
5
6,7,8,9
Back to Top
