TB-9-2320-279-13-P-2
TECHNICAL BULLETIN; CREW PROTECTION KIT
OPERATOR’S, UNIT AND DIRECT SUPPORT MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LISTS (RPSTL)
SEPTEMBER 2005
TB-9-2320-279-13-P-2 - Page 88 of 460
TB 9-2320-279-13&P-2
DOOR ASSEMBLY REPLACEMENT - CONTINUED
0015 00
0015 00-2
REMOVAL
1.
Open door assembly (1) and remove bolt (2), washer (3), and strap assembly (4) from top of door assembly.
2.
If strap assembly (4) is damaged, remove locknut (9), washer (8), bolt (5), washer (6), two bushings (7) and strap assem-
bly from door frame. Discard locknut.
NOTE
It may be necessary to install lifting links at top of door assembly.
3.
If necessary, install two lifting links (13), washers (11), bolts (10), and locknuts (12) on door assembly (1).
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death to per-
sonnel.
NOTE
Door assembly weighs 310 lb (141 kg).
4.
Attach sling and lifting device to lifting links (13) at top of door assembly (1).
Back to Top
