TB-9-2320-279-13-P-2
TECHNICAL BULLETIN; CREW PROTECTION KIT
OPERATOR’S, UNIT AND DIRECT SUPPORT MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LISTS (RPSTL)
SEPTEMBER 2005
TB-9-2320-279-13-P-2 - Page 91 of 460
TB 9-2320-279-13&P-2
DOOR ASSEMBLY REPLACEMENT - CONTINUED
0015 00
0015 00-5/(0015 00-6 Blank)
INSTALLATION - CONTINUED
NOTE
•
Perform step 8 if strap assembly was removed from door frame.
•
If door frame is new, refer to
Crew Protection Kit Installation Instructions
(WP 0039 00) for instruc-
tions on drilling holes in frame for installation of strap assembly.
8.
Install strap assembly (4) on door frame with two bushings (7), washer (6), bolt (5), washer (8), and new locknut (9).
WARNING
Use caution when using adhesives and sealants. Prolonged inhalation of vapors can cause lung irritation.
Contact with skin can cause dermatitis. Wear gloves and safety goggles and use product in a well-ventilated
area away from open flame. If ingested, keep individual calm and seek medical attention. DO NOT induce
vomiting. If contact with skin or eyes is made, flush thoroughly with water. Dispose of cleanup rags IAW
local policy and ordinances. Failure to follow this warning may cause injury to personnel.
9.
Apply thread adhesive to bolt (2). Install strap assembly (4), washer (3), and bolt (2) on door assembly.
10.
Adjust latch as necessary (WP 0016 00).
11.
Verify correct operation of door assembly.
12.
If removed, install outside mirror on door assembly (TM 9-2320-279-20).
END OF WORK PACKAGE
Back to Top
