TB-9-2320-279-13-P-2

TECHNICAL BULLETIN; CREW PROTECTION KIT

OPERATOR’S, UNIT AND DIRECT SUPPORT MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LISTS (RPSTL)

SEPTEMBER 2005
TB-9-2320-279-13-P-2

  TB-9-2320-279-13-P-2 - Page 94 of 460

Change 1
0015 01-2
TB 9-2320-279-13&P-2
DOOR ASSEMBLY REPLACEMENT - MODEL B - CONTINUED
0015 01
REMOVAL
1.
Remove two bolts (8) and washers (9) from door stop (5).
2.
Remove two bolts (6), washers (7), and door stop (5) from side of vehicle.
3.
Unlatch door and attach sling and lifting device to lifting link (3) at top of door assembly (4).
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death to per-
sonnel.
NOTE
Door assembly weighs 336 lb (153 kg).
4.
Using lifting device, remove five bolts, (1), washers (2), and door assembly (4) from door hinge (10).
5.
Place door assembly (4) on flat surface and remove sling and lifting device.
6.
Remove three bolts (11), washers (12), and hinge (10) from side of vehicle.
CLEANING AND INSPECTION
Clean and inspect all parts IAW
General Maintenance Instructions
(WP 0011 00).
440-055


Back to Top