TB-9-2350-277-40-P-4
CARRIER, COMMAND POST, FULL-TRACKED, ARMORED, M577A3; STANDARD INTEGRATED COMMAND POST SYSTEM (SICPS), M1068A3
TECHNICAL BULLETIN; INSTALLATION OF CREW II MODIFICATION KIT PART 4 OF 4
JUNE 2009
TB-9-2350-277-40-P-4 - Page 56 of 100
TB 9-2350-277-40&P-4
INSTALLATION PROCEDURES – Continued
0005 00
0005 00-20
INSTALL RCU CABLE, GPS CABLE, POWER HARNESS, AND RCU TO PDA CABLE
NOTE
Do not secure cables with tie straps until installation is complete and
the cables have been adjusted at both ends.
1.
Route RCU cable (29), GPS cable (13), and power harness (28) from rear of vehicle through
clamps (61) and (60) along right rail front of crew compartment.
2.
Secure cables (13), (28), and (29) together with tie straps (16).
Figure 19.
RCU Cable, GPS Cable, and Power Harness Installation
Back to Top
