TB-9-2350-277-40-P-4
CARRIER, COMMAND POST, FULL-TRACKED, ARMORED, M577A3; STANDARD INTEGRATED COMMAND POST SYSTEM (SICPS), M1068A3
TECHNICAL BULLETIN; INSTALLATION OF CREW II MODIFICATION KIT PART 4 OF 4
JUNE 2009
TB-9-2350-277-40-P-4 - Page 51 of 100
TB 9-2350-277-40&P-4
INSTALLATION PROCEDURES – Continued
0005 00
0005 00-15
2.
Install RCU/PDA bracket assembly to APU controller.
NOTE
A clamp is to be installed on the lower right screw of the RCU/PDA
bracket assembly.
Do not tighten screw securing clamp until cable
routing has been completed.
a.
Install RCU/PDA bracket assembly (52) to APU controller (53).
Secure with two screws (49),
lockwashers (50), and flat washers (51).
b.
Install clamp (54) to RCU/PDA bracket assembly (52) and APU controller (53).
Secure with
screw (49) and lockwasher (50).
Figure 14.
RCU/PDA Bracket Assembly Installation (M1068A3 Only)
Back to Top
