TB-9-2350-368-25
M113A2/M113A3/M548Al/M548A3 FAMILY OF VEHICLES INCLUDING OPPOSING FORCES SURROGATE VEHICLE (OSV)
FABRICATION AND OPERATION OF POWERPLANT TEST STAND
FEBRUARY 2003
TB-9-2350-368-25 - Page 19 of 120
TB 9-2350-368-25
2-5
NOTE
Total outside measurement of the forklift pockets must be 36 inches
to fit a standard forklift.
8. From bottom of frame, 26 inches from the end, weld two 9” vertical 2” by 4” supports on internal 2” by 4”
in accordance with Figure 2-4.
9. Center and weld 4” by 6” steel tubing on 9” vertical 2” by 4” supports.
10. Repeat steps 9 and 10 for the second forklift pocket and support.
Figure 2-4. Forklift Pockets
Back to Top
