TB-9-3950-253-13-P
PALLETIZED LOAD SYSTEM TRUCK, M1075 and M1075A1 (PLS) AND HEAVY EXPANDED MOBILITY TACTICAL TRUCK, M1120, M1120A2, AND M1120A4 (HEMTT), ENHANCED CONTAINER HANDLING UNIT (E-CHU)
TECHNICAL BULLETIN; OPERATOR AND FIELD MAINTENANCE, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LIST
JULY 2009
TB-9-3950-253-13-P - Page 394 of 704
0039-4
TB 9-3950-253-13&P
0039
REMOVAL – CONTINUED
00039
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use
assistance during procedure. Ensure any lifting device used is in good condition and of
suitable load capacity. Keep clear of heavy parts supported only by lifting device. Failure to
follow this warning may result in injury or death to personnel.
NOTE
Rear slider bed weighs 190 lb (86 kg).
5. Attach sling and lifting device to rear slider bed (Figure 3, Item 8).
6. Use lifting device to remove slack from sling.
7. Remove two bolts (Figure 3, Item 5), washers (Figure 3, Item 4), end plate (Figure 3, Item 3), and shim
(Figure 3, Item 2) from rear frame (Figure 3, Item 1).
8. Use lifting device to remove rear slider bed (Figure 3, Item 8) from rear frame (Figure 3, Item 1) and place on
flat surface.
9. Remove two bearings (Figure 3, Item 7) and shim (Figure 3, Item 6) from rear frame (Figure 3, Item 1).
Figure 3.
Rear Slider Bed Removal.
039
END OF TASK
CLEANING AND INSPECTION
00039
Clean and inspect all parts IAW WP 0020,
General Maintenance Instructions
.
END OF TASK
1
2
3
4
5
6
7
8
Back to Top
