TB-9-3950-253-13-P
PALLETIZED LOAD SYSTEM TRUCK, M1075 and M1075A1 (PLS) AND HEAVY EXPANDED MOBILITY TACTICAL TRUCK, M1120, M1120A2, AND M1120A4 (HEMTT), ENHANCED CONTAINER HANDLING UNIT (E-CHU)
TECHNICAL BULLETIN; OPERATOR AND FIELD MAINTENANCE, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LIST
JULY 2009
TB-9-3950-253-13-P - Page 395 of 704
0039-5
TB 9-3950-253-13&P
0039
INSTALLATION
00039
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use
assistance during procedure. Ensure any lifting device used is in good condition and of
suitable load capacity. Keep clear of heavy parts supported only by lifting device. Failure to
follow this warning may result in injury or death to personnel.
NOTE
•
Rear slider bed weighs 190 lb (86 kg).
•
Perform steps 1 through 11 for both side right and left sides.
1. Attach sling and lifting device to rear slider bed (Figure 4, Item 8).
2. Use lifting device to remove slack from sling.
3. Install shim (Figure 4, Item 6) and two bearings (Figure 4, Item 7) in rear frame (Figure 4, Item 1).
4. Use lifting device to install rear slider bed (Figure 4, Item 8) on rear frame (Figure 4, Item 1).
5. Install shim (Figure 4, Item 2), end plate (Figure 4, Item 3), two washers (Figure 4, Item 4), and bolts (Figure 4,
Item 5) on rear frame (Figure 4, Item 1).
6. Remove lifting device and sling from rear slider bed (Figure 4, Item 8).
7. Apply grease to fitting (Figure 4, Item 9).
Figure 4.
Rear Slider Bed Installation.
039
6
8
1
2
3
5
6
7
8
9
(HIDDEN)
Back to Top
