TM-5-5420-202-20-2

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 2 OF 4

OCTOBER 1985

TM-5-5420-202-20-2 - Page 161 of 734

TM 5-5420-202-20-2

LOWER OIL FILLER TUBE AND HOSE REPLACEMENT (Sheet 1 of 2)

TOOLS: 5/16 in. socket with 1/2 in. drive

5 in. extension with 1/2 in. drive

1/2 in. open end wrench

Putty knife

Ratchet with 1/2 in. drive

SUPPLIES:

Gasket

Drycleaning solvent (Item 55, Appendix D)

Rags (Item 65, Appendix D)

PRELIMINARY PROCEDURE:

Remove powerplant (page 5-2)

Gloves (Item 69, Appendix D)

Goggles (Item 70, Appendix D)

Dry cleaning solvent P-D-680 is toxic and flammable.

To prevent personal injury, wear

protective goggles and gloves and use only m a well-ventilated area. Avoid contact with skin,

eyes, and clothes and don’t breathe vapors.

Do not use near open flame or excessive heat. The

flash point for Type #1 Dry Cleaning Solvent is 100°F (38°C) and for Type #2 is 138°F (50°C).

If you become dizzy while using cleaning solvent, get fresh air immediately and get medical aid.

If contact with eyes is made, wash your eyes with water and get medical aid immediately.

REMOVAL:

NOTE

Clean all parts and general area prior to removal.

1.

Using 5/16 inch socket, loosen two clamps (A) from hose (B).

2.

Using 1/2 inch wrench, remove three screws (C) and lockwashers (D) from tube assembly

(E).

3.

Pull tube assembly (E) and hose (B) loose

4.

Using putty knife, remove gasket (F) and

Go on to Sheet 2

and slip off two clamps (A).

throw away.

6-88