TM-5-5420-202-20-2

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 2 OF 4

OCTOBER 1985

TM-5-5420-202-20-2 - Page 163 of 734

TM 5-5420-202-20-2

TURBOSUPERCHARGER OIL DRAIN TUBE (RIGHT BANK) REPLACEMENT

(Sheet 1 of 4)

PROCEDURE INDEX

PROCEDURE

Removal

Inspection

Installation

TOOLS:

1/2 in. socket with 1/2 in. drive

Ratchet with 1/2 in. drive

Flat-tip screwdriver

5/16 in. combination box and open end wrench

SPECIAL TOOLS: Ground hop kit

SPECIAL TOOLS:

Ground hop kit (Item 31, Chapter 3, Section I)

SUPPLIES:

Lubricating oil (Item 44, Appendix D)

Gasket

REFERENCES:

LO 5-5420-202-12

PRELIMINARY PROCEDURES:

Remove powerplant (page 5-2)

Drain engine oil (page 6-1 2)

Remove generator

(page 10-6)

PAGE

6-90

6-91

6-92

NOTE

If clamp (A) cannot be loosened with

screwdriver, use 5/16-inch combination

REMOVAL:

box and open end wrench.

1.

Using screwdriver, loosen six clamps (A) on three hoses (B) on each end of upper drain tube.

Go on to Sheet 2

6-90