TM-5-5420-202-20-3
M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4
OCTOBER 1985
TM-5-5420-202-20-3 - Page 470 of 1060
TM 5-5420-202-20-3
ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR (Sheet 2 of 18)
Male Plug Repair (Sheet 1 of 3)
TOOLS: Electrical connector repair tool kit
Soldering gun
Slip joint pliers with plastic jaw inserts
Diagonal cutting pliers
SUPPLIES:
Silicone compound (Item 32, Appendix D)
Jumper wire
Electrician’s tape (Item 59, Appendix D)
PRELIMINARY PROCEDURES:
Disconnect three battery ground straps (page 10-268)
Loosen or remove cable clamps as required
Disconnect connectors at each end of affected cable
1.
2.
5.
6.
Manually remove grommet retaining nut
(A) from plug assembly (B).
Slide grommet retaining nut (A) back
along cable (C).
Using diagonal pliers, cut wire from
contact (E). Throw away contact (E).
Pulling cut wire out of grommet (D), use
diagonal cutting pliers to shorten wire
about 6 inches. Fasten end of cut wire
to cable (C) with friction tape.
G
O
on to Sheet 2
3.
Using slip joint pliers, work grommet (D)
back and forth and out of plug assembly
(B).
4.
Using remover, push contact (E) with
damaged wire out of back of plug
assembly (B).
10-299
Back to Top
