TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 473 of 1060

TM 5-5420-202-20-3

ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR (Sheet 5 of 18)

Male Connector Repair (Sheet 1 of 1)

TOOLS:

Electrical connector repair tool kit

Diagonal cutting pliers

SUPPLIES:

Silicone compound (Item 32, Appendix. D)

Electrician’s tape (Item 59, Appendix D)

PRELIMINARY PROCEDURES:

Disconnect three battery straps (page 10-268)

1.

Slide shell (A) back along cable (B)

3. Using hand

from cable

wire stripper, strip insulation

(B) equal to well depth in

terminal (C).

4.

Insert stripped cable end (E) into well in

terminal (C).

2. Using diagonal cutting pliers, cut

terminal (C) and C-washer (D) from cable

(B). Throw terminal (C) and C-washer (D)

away.

5. Using crimping tool, crimp terminal (C).

6. Push new C-washer (D) onto cable (B) at

rear of terminal (C).

7. Slide shell (4) forward along cable (B) until tight against C-washer (D).

8.

9.

End

Using multimeter, check continuity of repaired circuit.

Connect three battery ground straps (page 10-268).

of Task

TA249243

10-302