TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 482 of 1060

TM 5-5420-202-20-3

ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR (Sheet 14 of 18)

Female Connector With Washer (12 Gauge Cable) Repair (Sheet 1 of 1)

TOOLS:

Electrical connector repair tool kit

Diagonal cutting pliers

SUPPLIES:

Silicone compound

PRELIMINARY PROCEDURES:

(Item 32, Appendix D)

Disconnect three battery ground straps (page 10-268)

Loosen or remove cable clamps as required

1.

3.

4.

7.

8.

9.

10.

Slide shell (A) back along cable (B).

2.

Using diagonal cutting pliers, cut

terminal (C) and washer (D) from

cable (B). Throw terminal (C) and

washer (D) away.

Using hand wire stripper, strip insulation

from cable (B) equal to well depth in

terminal (C).

Slide new washer (D) onto stripped cable

end (E) back to cable insulation.

5.

Insert stripped cable end (E) into well in

terminal (C).

6. Using crimping tool, crimp terminal (C).

Slide shell (A) forward until tight against washer (D).

Using multimeter, check continuity of repaired circuit.

Tighten or install cable clamps as required.

Connect three battery ground straps (page 10-268).

End of Task

TA249252

10-311